Frequently Asked Questions about Precision Shot

1. Can I get Refills or Replacements for my kits?

Absolutely! You can buy individual refilles here. If you bought your Precision Shot Kit from a dealer, they should have the refills for the Kit which you originally purchased from them.

2. Can I get more tips and accessories?

Sure! You can buy more Tips by clicking here. If you purchased our products offline, your dealer should have the tips and accessories.

3. It's hard to get the product out of the tip. What's wrong?

There are several causes for this issue. Thickness of the material is the first issue. For instance, oils will come out of all the tips easily (too easily out of the large needles), whereas a thick sealant will be tougher to get through a smaller tip. We recommend the following:

• GREASES - Start with the Yellow or Pink metal tips
• OILS - Start with the Black or Yellow metal tips
• ADHESIVES - For the Threadlockers you must only use the All Plastic Taper tips, NO METAL!
• For the Contact Cement, Polyurethane Glue, and Carpenters Glue, we recommend the Yellow tip first and then move up or down to the Pink or Black tip if required.

4. Can I leave the tips on the syringe?

In most instances you can! Simply put the appropriate tip cap on and put it back into the case. The foam is slit to accept the attached tip!

5. Is there a shelf life on the materials?

Some materials do have a shelf life and some do not. Because of their nature, Adhesives and Sealants do have a shelf life.

6. Why are the Threadlockers not full of material?

Threadlockers cure differently than most other adhesives. They are called anaerobic adhesives and thus cure with an ABSENCE of air. Therefore they must have air in the container to keep them from curing! They compound their curing abilities when they come in contact with metal as well! Therefore, we highly recommend that you do not use the metal tips, since the combination of metal and the absence of air while traveling down the these narrow tips will make the material cure very quickly.

7. Do you have longer tips available?

Yes, we do! You may contact your dealer or check out our refills page

8. The material keeps coming out after I have stopped pressing the plunger. What is causing this?

Slightly pull back on the plunger to stop the pressure and flow.